25. janeiro 2023

The FX100 Audio Analyzer combined with the Larson Davis binaural headphone and earphone test fixture are the ideal combination for measurements of over-ear, on-ear and in-ear headphones.

The Larson Davis Model provides precise mechanical positioning of headphones. The two built-in ear simulators with pinna and microphones allow measurements according to the IEC 60318 (IEC 60711) standard.

Configuration

An FX100 Audio Analyzer is used, controlled by the FX-Control Software. This controls the measurement sequence. The two microphones of the binaural headphone and earphone test fixture are directly connected to the FX100.

Test Signal

Glide sweep, noise or sinusoidal signals are typically used. These can be transmitted from the FX100 electrically, or wirelessly to the headphones via the NTi Audio Bluetooth Box.

Sound Recording

The sound emitted by the headphones is then picked up by the built-in microphones, and passed to the FX100 Audio Analyzer.

Analysis

From the measured microphone signals, various headphone parameters can be determined. Typical parameters are sensitivity, frequency response, distortion and phase response. For models with an ANC (Active Noise Cancellation) function, the active, passive and total sound reduction of the headphone or earphone is also determined.

Webinar

Register for our webinar "Measurements of ANC (Active Noise Cancellation) headphones and earphones" on 16 February 2023.

Further Information

NTi Audio FX100 Audio Analyzer
Larson Davis Headphone Test Equipment
Do you have any questions? Contact us at info@nti-audio.com